|
|
|||||||
| VoIP & Your Hardware/Software Cisco, Linksys, Sipura, Netgear, Grandstream, Polycom, Xten, etc. |
|
|
Thread Tools | Display Modes |
24-07-06, 12:24 AM
|
#1 |
|
Junior Member
Join Date: Jul 2006
Posts: 3
|
Netgear TA612v Phone 2
I enabled Phone 2 on my Netgear ta612v and have 1 cordless phone connected to port 1 and another connected to port 2.
When the phone rings only the cordless phone connected to port 1 rings. When the phone on port 1 is on a call and someone rings my number they hear a tone like it is calling but the phone dosent ring. When the phone on port 2 is on a call and someone rings my number the phone on port 1 rings. I swapped the phones from port 1 and port 2 and it is the same situation so I presume it is a setting on port 2 that I have wrong? |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Constant Busy Signal using Netgear TA612V | gregc | VoIP & Your Hardware/Software | 5 | 15-01-07 02:50 PM |
| Problem setting up netgear ta612v | cubix | VoIP & Your Hardware/Software | 2 | 29-10-06 02:41 PM |
| Netgear TA612v Connection setup | BFSGuru | Minimising Connection Issues | 0 | 09-10-06 02:08 PM |
| Netgear ta612v problems | gyro | VoIP & Your Hardware/Software | 8 | 17-09-06 10:46 AM |
| Linksys WRT54G and Netgear TA612V | teresak | VoIP & Your Hardware/Software | 3 | 23-07-06 05:34 PM |
Threaded Mode